OctoPrint¶

OctoPrint The snappy web interface for your 3D printer.

Setup¶

To find the serial port and connect to your printer run

ls /dev/serial/by-id/*

then, set the value that corresponds to the 3D printer by going into the config file and under octoprint (in the devices array) add the address that you recieved in the previous step. Using the pattern:

  devices: ['/dev/device1', '/dev/device2']

Access¶

It is available at https://{% if octoprint.domain %}{{ octoprint.domain }}{% else %}{{ octoprint.subdomain + "." + domain }}{% endif %}/ or http://{% if octoprint.domain %}{{ octoprint.domain }}{% else %}{{ octoprint.subdomain + "." + domain }}{% endif %}/

{% if enable_tor %} It is also available via Tor at http://{{ octoprint.subdomain + "." + tor_domain }}/ {% endif %}

Security enable/disable https_only and auth¶

To enable https_only or auth set the service config to True settings/config.yml

octoprint:
  https_only: True
  auth: True
  serial: False